Step 1 - Dig a planting hole to the proper depth for the plant.
Step 2 - Water hole. Carefully cut the bottom off the carton where indicated, exposing the DRiWATER
Step 3 - Place plant in hole and install the Quart as shown above. The bottom of the Quart should be directly against the root mass. When using multiple Quarts, place at equal distances around plant. Backfill the hole with soil
Step 4 – Water plant throughly.
Hints & Tips:
Step 1 - Water plant thoroughly before applying Driwater.
Step 2 - Open Gel Pac by cutting from end to end. Pull sides of plastic casing apart to expose entire length of the DRiWATER. Do not remove DRiWATER from casing when using directly on the soil surface.
Step 3 - Place on moist soil surface, with opening face down, next to the stem of the plant. (It is important that the DRiWATER touches the soil so liquefaction can begin.) The Gel Pacs can be cut in half with casing on. Gel Pacs are pliable once the casing is sliced open and will bend to form fit container.
Step 4 – Replace when empty. (30 days)
|We Also Recommend :|